The Serical 3000 and 300 have a new features: photometer-corrected titration points.Serinus instruments all allow three analog outputs, which can be bound to any loggable data value (instead of being restricted to the measured gas concentration).The Serical 10 allow a single analog output if the optional source MFC is not installed (the 3000 already had this feature).The Reserved bits are now in the correct order and the Idle mask applies zeros as expected. Digital IO bits are improved on the Serical.This is particularly useful if the calibration process is shorter than the measurement logging or average period. Serinus now allows separate periods for calibration data logging and averaging.EEPROM mirroring protects instrument configuration from corruption during power-up.Improvement of periodic averaging, including the ability to set a minimum amount of data captures to create a valid average.Improvements when using an S50 to measure only H2S.Serial port communications allow specifying parity.Supports the Rev B Ozone DAC control board (required for all new S10 and Serical instruments and field upgrades to S10 IZS).Version 3 is not compatible with older mainboards. Note: if your instrument already contains firmware Version 1 or Version 2 variations, do not upgrade with this firmware. This includes Serinus Analysers and Serinus Calĭesigned for Revision J and above Serinus main controller PCA designed for all Serinus Cal main controller PCA Serinus Series – Version 3 Serinus Firmware Firmware can be downloaded below: Gas Analysers/Gas Dilution Calibrators As ECOTECH continue to implement improvements and new innovations to its instruments, the firmware of these products can be updated to incorporate these improvements.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |